Hey Everyone,

I’m looking to get an air compressor for some work around the house. It would mostly be used for nail guns to replace siding and trim. However, I do want to be able to spray wall texture occasionally (The walls have been “fixed” in various spots and I’m probably going to redo entire walls. A couple of walls are so bad I think they just threw the sprayer in the room and ran away). I’m fine with going slow when spraying texture as long as I can still get a good result. The compressor I’m looking at is a 6 gallon @ 175 PSI, with 3.0 SCFM @ 90 PSI. This seems perfect for nail guns ( I think), but texture guns seem to consume 2-9 SCFM. Do you that will be fine for periodic use, or will it be maddening slow? My goal would be to texture and paint a roughly 10ft by 12ft room in a weekend. I’ll be using a roller and brush for paint so that is not a concern.

Sorry if its a silly question, but when researching this stuff it’s getting so hard to find non-ai generated website’s that are just trying to sell shit.

I went to put in an outlet with charging ports and found this monstrosity behind the wall plate. The box is filled with expanding foam, I’m guessing as some kind of support? Then painted all over. I scraped it all out, put in outlet spacers and its much better. I think there’s foam around the box too, but I’m not gonna worry about that (yet).

Now I get to spend next weekend replacing all the outlets in the house just in case there’s any more sketchy “fixes” 🫠

After cleaning and replacing: